☺ Buildbot (Sourceware): gdb-try-debian-armhf - build successful (users/simark/try-remove-vlas)

A passing build has been detected on builder gdb-try-debian-armhf while building binutils-gdb.

Full details are available at:
    https://builder.sourceware.org/buildbot/#/builders/334/builds/43

Build state: build successful
Revision: 35c840cc642359065d91beb6a6197101bb633ff2
Worker: debian-armhf
Build Reason: (unknown)
Blamelist: Alan Modra <[email protected]>, Alexandra Hájková <[email protected]>, Andrew Burgess <[email protected]>, GDB Administrator <[email protected]>, Jan Beulich <[email protected]>, Lulu Cai <[email protected]>, Nick Clifton <[email protected]>, Pali Rohár <[email protected]>, Simon Marchi <[email protected]>, Tom de Vries <[email protected]>, Vladimir Mezentsev <[email protected]>, YunQiang Su <[email protected]>

Steps:

- 0: worker_preparation ( success )

- 1: git checkout ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/1/logs/stdio

- 2: rm -rf gdb-build ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/2/logs/stdio

- 3: configure ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/3/logs/stdio
        - config.log: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/3/logs/config_log

- 4: make ( warnings )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/4/logs/stdio
        - warnings (20): https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/4/logs/warnings__20_

- 5: prep ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/5/logs/stdio

- 6: fetch ['../gdb-build/gdb/config.log'] ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/6/logs/stdio

- 7: pass .bunsen.source.* ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/7/logs/stdio

- 8: upload to bunsen ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/8/logs/stdio

- 9: clean up ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/9/logs/stdio

- 10: rm -rf gdb-build_1 ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/334/builds/43/steps/10/logs/stdio