Re: Problem with continue/halt

W dniu 2014-06-26 17:24, Eli Zaretskii pisze:
> Are you per chance compiling with LTO?  If so, don't.

I'm using the same command as the one which worked fine previously:

> $SRCDIR/$BINUTILS_GDB/configure --build=$BUILD \
>     --host=$HOST_MINGW \
>     --target=$TARGET \
>     --prefix=$INSTALLDIR_MINGW \
>     --infodir=$INSTALLDIR_MINGW_DOC/info \
>     --mandir=$INSTALLDIR_MINGW_DOC/man \
>     --htmldir=$INSTALLDIR_MINGW_DOC/html \
>     --pdfdir=$INSTALLDIR_MINGW_DOC/pdf \
>     --disable-nls \
>     --enable-plugins \
>     --with-sysroot=$INSTALLDIR_MINGW/arm-none-eabi \
>     --disable-sim \
>     --with-python=no \
>     --with-lzma=no \
>     --with-libexpat=$BUILDDIR_MINGW/host-libs/usr \
>     --with-libiconv-prefix=$BUILDDIR_MINGW/host-libs/usr \
>     --with-system-gdbinit=$INSTALLDIR_MINGW/$HOST_MINGW/arm-none-eabi/lib/gdbinit \
>     '--with-gdb-datadir='\''${prefix}'\''/arm-none-eabi/share/gdb' \
>     "--with-pkgversion=$PKGVERSION"
>
>     make -j$JOBS

So I'm not enabling LTO explicitly, maybe that's enabled by default somehow?

BTW - do you mean LTO is the cause for the continue/halt problem or the 
issue of building older versions?

Regards,
FCh