Re: repeat command on return after issuing guile command
Eli Zaretskii <[email protected]>
| Newsgroups | gmane.comp.gdb.devel |
|---|---|
| Message-ID | <[email protected]> |
> From: David Boles <[email protected]> > Date: Fri, 28 Apr 2017 22:50:18 -0500 > > I have recently been learning to use the guile mechanism for extending gdb’s capabilities - very powerful. One thing that I have noticed is that after a “guile (…)” command is issued, the normal behavior of gdb re-performing the last command executed if you just hit enter is disabled. This applies to even native gdb commands like “next” or “step” - which is quite painful. > > I have observed this with versions 7.10.x and 7.12.1. I cannot reproduce this with GDB 7.12 built with Guile 2.0.X. I tried this: (gdb) apropos file ... long list of commands ... (gdb) <press RET> ... the same long list of commands ... (gdb) guile (display (+ 20 3)) (newline) 23 (gdb) apropos file ... long list of commands ... (gdb) <press RET> ... the same long list of commands ... So it seems to work as expected for me. Can you show a recipe that exhibits the problem on your system?