Re: gdb ignoring vCont supported commands

On Tue, Oct 9, 2018 at 3:16 PM Simon Marchi <[email protected]> wrote:

> On 2018-10-09 16:12, Bill Morgan wrote:
> > I get a warning that vContSupported is unrecognized:
> >
> > Sending packet:
> >
> $qSupported:multiprocess+;swbreak+;hwbreak+;qRelocInsn+;fork-events+;vfork-events+;exec-events+;vContSupported+;QThreadEvents+;no-resumed+#df...Ack
> > Packet received:
> >
> PacketSize=3fff;QPassSignals+;qXfer:features:read+;qXfer:threads:read+;vContSupported
> > Packet qSupported (supported-packets) is supported
> > warning: unrecognized item "vContSupported" in "qSupported" response
>
> I believe you are missing the + after vContSupported.
>
> You are correct, I was missing the +. Thank you.

So it is now recognizing the vContSupported, but it is still sending
vCont;s

Sending packet:
$qSupported:multiprocess+;swbreak+;hwbreak+;qRelocInsn+;fork-events+;vfork-events+;exec-events+;vContSupported+;QThreadEvents+;no-resumed+#df...Ack
Packet received:
PacketSize=3fff;QPassSignals+;qXfer:features:read+;qXfer:threads:read+;vContSupported+
Packet qSupported (supported-packets) is supported

<snip>

Sending packet: $vCont?#49...Ack
Packet received: vCont;c;C
Packet vCont (verbose-resume) is supported

<snip>

(gdb) s
Sending packet: $QPassSignals:#f3...Ack
Packet received: OK
Sending packet: $vCont;s:13#56...Ack
Packet received: E01
warning: Remote failure reply: E01


Simon
>