where to put defines for exception numbers as encoded in ARM CoreSight ETM traces
Zied Guermazi <[email protected]>
| Newsgroups | gmane.comp.gdb.devel |
|---|---|
| Message-ID | <[email protected]> |
hi in ETM traces (3.4 and above), exception encodings for non v7m processors (v7A, is done in a 4 bit field, defined in table 7.12 - (https://developer.arm.com/documentation/ihi0014/q/ETMv3-Signal-Protocol/Instruction-tracing/Branch-Packets?lang=en#BABIECBB <https://developer.arm.com/documentation/ihi0014/q/ETMv3-Signal-Protocol/Instruction-tracing/Branch-Packets?lang=en#BABIECBB>). This is not the same encoding as for exception vector. This is needed for handling the implementation of breakpoints as an undefined instruction trap in GDB for ARMv7 while decoding ETM traces (branch tracing extension to use ARM CoreSight ETM) what will be a good location for adding defines for this exception encoding? will it be fine to add them in arch/arm.h? shall I create a new header file for them? please advise. Kind Regards Zied Guermazi