Refresh TUI source panel after "monitor reset"

"R. Diez via Gdb" <[email protected]>
Newsgroups gmane.comp.gdb.devel
Message-ID <[email protected]> 
Hi all:

I have been using GDB with OpenOCD for quite a while in order to program and debug embedded software on an STM32 microcontroller.

I have learnt that, after a "monitor reset halt" (which resets the CPU), GDB still keeps the cached values of the CPU registers, but you can workaround it with command "flushregs".

There is one thing that is still bugging me though: in TUI mode, the source pane does not refresh until the current instruction is executed.

Is there a way to refresh the source pane after "flushregs"? I tried "maint flush source-cache" and "refresh", but they did not help.

Thanks in advance,
   rdiez
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.