Re: gdb says that "disassemble /m" is not a valid command

Hello!

On Fri, Aug 14, 2009 at 05:53:16PM +0300, Nikos Chantziaras wrote:
> On 08/14/2009 11:22 AM, Thomas Schwinge wrote:
> >On Wed, Aug 12, 2009 at 07:44:35PM +0300, Nikos Chantziaras wrote:
> >>   (gdb) disassemble /m
> >>   A syntax error in expression, near `/m'.
> >>
> >>Is the documentation out of date?  How do I get source and assembly at
> >>the same time?  "help disassemble" doesn't say anything about "/m" and
> >>neither the gdb info pages.
> >
> >Your version of GDB is too old
> 
> 6.8 is the latest release I can find on 
> http://www.gnu.org/software/gdb/download/

This is correct, the new release has not yet been done.  If using the
last release, you should have a look at ``the documentation generated
from the last release'' -- see
<http://www.gnu.org/software/gdb/documentation/>.


Regards,
 Thomas

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2.2 (GNU/Linux)

iD8DBQFKhpv0smqaiQAHQR4RAks2AJ4k9qv9iFMchKO7UUXCGIZ1efU8hQCgrikE
7AuUU4gI0R+kcA4SQ8qsSGI=
=4jjL
-----END PGP SIGNATURE-----