☺ Buildbot (Sourceware): binutils-gdb - build successful (master)

A restored build has been detected on builder gdb-debian-armhf while building binutils-gdb.

Full details are available at:
    https://builder.sourceware.org/buildbot/#/builders/72/builds/7835

Build state: build successful
Revision: 078e4676be5d047ccaf7ec316cbb0c6cbd17e00d
Worker: debian-armhf
Build Reason: (unknown)
Blamelist: Tankut Baris Aktemur <[email protected]>

Steps:

- 0: worker_preparation ( success )

- 1: git checkout ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/1/logs/stdio

- 2: rm -rf gdb-build ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/2/logs/stdio

- 3: configure ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/3/logs/stdio
        - config.log: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/3/logs/config_log

- 4: make ( warnings )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/4/logs/stdio
        - warnings (20): https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/4/logs/warnings__20_

- 5: prep ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/5/logs/stdio

- 6: collect system versions ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/6/logs/stdio

- 7: fetch .bunsen.* ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/7/logs/stdio

- 8: build bunsen.cpio.gz ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/8/logs/stdio

- 9: fetch bunsen.cpio.gz ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/9/logs/stdio

- 10: unpack bunsen.cpio.gz ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/10/logs/stdio

- 11: pass .bunsen.source.* ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/11/logs/stdio

- 12: upload to bunsen ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/12/logs/stdio

- 13: clean up ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/13/logs/stdio

- 14: rm -rf gdb-build_1 ( success )
    Logs:
        - stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7835/steps/14/logs/stdio