☺ Buildbot (Sourceware): binutils-gdb - build successful (master)
builder--- via Gdb-testers <[email protected]>
| Newsgroups | gmane.comp.gdb.testing |
|---|---|
| Message-ID | <[email protected]> |
A restored build has been detected on builder gdb-debian-armhf while building binutils-gdb.
Full details are available at:
https://builder.sourceware.org/buildbot/#/builders/72/builds/7932
Build state: build successful
Revision: c31b2aaf5839e54b7d4778ca495da5514fae9a78
Worker: debian-armhf
Build Reason: (unknown)
Blamelist: GDB Administrator <[email protected]>, Georg-Johann Lay <[email protected]>
Steps:
- 0: worker_preparation ( success )
- 1: git checkout ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/1/logs/stdio
- 2: rm -rf gdb-build ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/2/logs/stdio
- 3: configure ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/3/logs/stdio
- config.log: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/3/logs/config_log
- 4: make ( warnings )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/4/logs/stdio
- warnings (20): https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/4/logs/warnings__20_
- 5: prep ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/5/logs/stdio
- 6: collect system versions ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/6/logs/stdio
- 7: fetch .bunsen.* ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/7/logs/stdio
- 8: build bunsen.cpio.gz ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/8/logs/stdio
- 9: fetch bunsen.cpio.gz ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/9/logs/stdio
- 10: unpack bunsen.cpio.gz ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/10/logs/stdio
- 11: pass .bunsen.source.* ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/11/logs/stdio
- 12: upload to bunsen ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/12/logs/stdio
- 13: clean up ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/13/logs/stdio
- 14: rm -rf gdb-build_1 ( success )
Logs:
- stdio: https://builder.sourceware.org/buildbot/#/builders/72/builds/7932/steps/14/logs/stdio