GDAL Process Exit Codes and stderr
Peter Townsend via gdal-dev <[email protected]>
| Newsgroups | gmane.comp.gis.gdal.devel |
|---|---|
| Message-ID | <CAMQBGmW284ZtbBarL4-RXeibQVFaH-GpDNVonzaw3cF3rS9bBw@mail.gmail.com> |
I thought it'd be easiest to just ask. When you run any of the GDAL executables, is it a safe assumption to say that if the process exit code is 0 that it really did succeed at whatever you told it to do? Despite whether it wrote anything out to stderr? To word it a bit differently, if the process code is not zero, can I assume that it didn't work out and I should stop whatever I was doing with GDAL? I'm using v3.9.3 if that helps narrow down the behavior. Thanks! -- Peter Townsend Senior Software Developer _______________________________________________ gdal-dev mailing list [email protected] https://lists.osgeo.org/mailman/listinfo/gdal-dev