Re: newbie question about mapproject

Hi Bruce-

Could you make a small portion that demonstrates the fail (or otherwise the entire file) of your input file available so I can debug?
-p

On Apr 23, 2014, at 2:29 AM, Bruce Bowler <[email protected]> wrote:

> I have some code written by someone else that uses 4.something.  I have
> 5.1.1 on my machine.
> 
> One of the commands that was in the original was 
> 
> mapproject -R-124/-116.5/31.25/38 -JQ-120.25/14.4 -bis3 -bos3 -S  -V
> 
> (as part of a pipe stream)
> 
> I've changed that to
> 
> mapproject -R-71/-65/41/45 -JQ-68/43.5 -bi3f -bo3f -S  -V < ptemp >
> mtemp
> 
> and taken the pipe out of the picture by having the previous command
> output to ptemp.
> 
> The problem is that command will run for hours, so clearly I need to do
> something else, but I'm not sure what.
> 
> Any hints most graciously accepted...
> 
> Bruce
> 
> -- 
> +-------------------+---------------------------------------------------+
> Bruce Bowler        | Honesty has ruined more marriages than infidelity.
> 1.207.315.2567 x503 | 
> [email protected] | - Charles McCabe 
> +-------------------+---------------------------------------------------+
> 
> To unsubscribe, send the message "signoff gmt-help" to [email protected]

To unsubscribe, send the message "signoff gmt-help" to [email protected]