Re: [Q/Patch] libresolv?

Hi Jack:

On 02/02/2020 02:09:35 PM Sun, Jack via balsa-list wrote:
> Hello all,
> 
> On 2020.02.02 12:41, Peter Bloomfield wrote:
…
>> I just used the autotools to build Balsa out-of-tree in a clean directory with no issues (starting with "path/to/Balsa/autogen.sh", followed by "make"). Interestingly, config.h was created, but there's no sign of config.h.in. Previously, I was testing the autotools build just using "make" in an existing directory, which was probably quite old and crusty1
> 
> I have run into this on occasion, but not recently, and of course have forgotten the exact error/warning messages.  Haven't at least some .in files been either deprecated by or actually produced from the .am or .ac files by autogen.sh? (I suppose I miss many of these messages if I use meson/ninja instead of autogen.sh/make.)
> 
> Jack

Yes, I rarely build with autotools, so I forget how it works. Turns out that config.h.in *is* created (at "make" time), but in the source directory, not the build directory. I've restored it to .gitignore, so that "git status" doesn't list it as untracked.

Peter

_______________________________________________
balsa-list mailing list
[email protected]
https://mail.gnome.org/mailman/listinfo/balsa-list

-----BEGIN PGP SIGNATURE-----

iF0EABECAB0WIQS030wPRfNNA5alz3MfX9S1uSp09QUCXjgefQAKCRAfX9S1uSp0
9ZNlAJ9kdQ4J5r8IkmLDvwNJtDJpnxUlKwCgiDcIgqIqLHOVfIY0kWAvL+TUT90=
=RLfI
-----END PGP SIGNATURE-----