Re: Issues with gkrellm-uguru and gkrellm-hddtemp

Bill,

No, you understood correctly, get zero values for the sensors. However, I
still get zero values with the new code as well. I'll investigate further
and see if I can rectify that. I think I saw something in the notes about
sensors not looking in the new location if senors are enabled, so I'll have
to see about getting that driver unloaded and try again.

Regards,
Steven

On 8/12/06, Bill WIlson <[email protected]> wrote:
>
> On Fri, 11 Aug 2006 11:28:38 -0600
> "Steven Collins" <[email protected]> wrote:
>
> > Finally got the chance last night to download this, build it, and give
> it a
> > try. Everything went smoothly, except I did lose my configuration when I
> > started the new version. Not a big problem to restore manually. I do
> wonder
> > what is supposed to be new with this version though. I could find no
> changes
> > in behavior.
>
> I thought you weren't getting sensor readings.  You originally said you
> were getting all zero gkrellm-uguru readings and then:
> >  I have Hans' code installed (which I hadn't done yet when you
> >  responded) and get see the readings from the M/B in the files he
> creates in
> >  the "/sys" filesystem. Unfortunately sensors can't yet read that data.
>
> So this new version will read sensors from the new kernel /sys locations
> so it should have let you start to get sensor readings.  But sorry if I
> misunderstood and you were already getting readings, in which case
> the new version doesn't gain you anything.  But it ultimately will be
> necessary for everybody since sensor readings from the kernel /sys
> filesystem is in the process of changing.
>
> Bill
> _______________________________________________
> Gkrellm mailing list
> [email protected]
> http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm
>

_______________________________________________
Gkrellm mailing list
[email protected]
http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm