Re: Disable libsensors in 2.2.9
Ian Pilcher <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gkrellm |
|---|---|
| Message-ID | <[email protected]> |
Bill WIlson wrote: > That patch is the one that was sent to me for libsensors support, but I don't think > it was quite ready for general use because it cuts out the gkrellm sysfs code and it > does not try to migrate the config. In 2.2.10 I fixed both of those issues and added > the switch to allow running from either interface. In the patched 2.2.9 you have > there is no way to get it to switch to reading from sysfs. But then that won't matter > either if the sysfs names are of the "2.0V" type, and if that's the case, I would > like to see a listing of all the names in the directory. [pilcher@home sys]$ cd /sys/devices/platform/i2c-9191/9191-6000 [pilcher@home 9191-6000]$ ls alarms fan2_input in1_max in3_min temp1_input temp3_max bus fan2_min in1_min in4_input temp1_max temp3_max_hyst driver hwmon:hwmon0 in2_input in4_max temp1_max_hyst uevent fan1_div in0_input in2_max in4_min temp2_input fan1_input in0_max in2_min name temp2_max fan1_min in0_min in3_input power temp2_max_hyst fan2_div in1_input in3_max subsystem temp3_input The sysfs devices have the correct names, but the library is "auto- magically" mapping them to what it believes (incorrectly) are the proper human-readable names. -- ======================================================================== Ian Pilcher [email protected] ======================================================================== _______________________________________________ Gkrellm mailing list [email protected] http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm