Re: temps not being picked up by gkrellm
Bill WIlson <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gkrellm |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 31 Dec 2006 23:14:31 -0600 MillTek <[email protected]> wrote: > I run Arch Linux on a MSI K9N6GM mainboard under Kernel 2.6.19. I have > tried following the instructions on the Arch Wiki to set up gkrellm for > all the sensors on my board. > > I get the Nvidia GPU temp, but not the cpu and northbridge. If I run > sensors in a terminal it reports them as follows; > > sensors > k8temp-pci-00c3 > Adapter: PCI adapter > CPU Temp: +25°C > Via Chip Temp: > +24°C > > These are not picked up by gkrellm. Anyone have any ideas what I can do?? Are you running gkrellm 2.2.10? k8temp support wasn't available until that version. Otherwise, what does the sensor debug output say? Run: gkrellm -d 0x80 Bill _______________________________________________ Gkrellm mailing list [email protected] http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm