Re: temps not being picked up by gkrellm

HI Bill,

Installing 2.2.10 worked.  IS there a way to pick up the fan speeds from 
the BIOS??


Thanks (for both a neat utility and your reply)
Jim



Bill WIlson wrote:
> On Sun, 31 Dec 2006 23:14:31 -0600
> MillTek <[email protected]> wrote:
>
>   
>> I run Arch Linux on a MSI K9N6GM mainboard under Kernel 2.6.19.  I have 
>> tried following the instructions on the Arch Wiki to set up gkrellm for 
>> all the sensors on my board.
>>
>> I get the Nvidia GPU temp, but not the cpu and northbridge. If I run 
>> sensors in a terminal it reports them as follows;
>>
>> sensors
>> k8temp-pci-00c3
>> Adapter: PCI adapter
>> CPU Temp:    +25°C
>> Via Chip Temp:
>>              +24°C
>>
>> These are not picked up by gkrellm. Anyone have any ideas what I can do??
>>     
>
> Are you running gkrellm 2.2.10?  k8temp support wasn't available until that
> version.
>
> Otherwise, what does the sensor debug output say?  Run:  gkrellm -d 0x80
>
> Bill
> _______________________________________________
> Gkrellm mailing list
> [email protected]
> http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm
>
>   

_______________________________________________
Gkrellm mailing list
[email protected]
http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm