Re: Some voltage readings, off & low when they are not
Bill Wilson <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gkrellm |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 26 Jan 2008 14:51:17 -0500 Gene Heskett <[email protected]> wrote: > I just called and arranged for another psu for this box as the gkrellm is > saying the +5 volt line is running in the 4.6-4.7 range, and the -5 volts is > showing at about -3.5. > > Sticking a good digital meter in the end of a long chain of drive connectors, > (this box has a bunch of extra stuff in it, and a 400Watt HiPro supply about > 3 months old) I'm getting a stable reading of 4.98 volts. Getting at the -5 > line is difficult, the board connector is on the other side of a drive cage > with 3 drives in it, so I have NDI what it actually is. > > The ability to adjust the scales and offsets in the voltage config display is > greyed out, so how does one go about this? > > An lsof says it is using libsensors.so.3.1.4. There are a couple of gkrellm > files in the sysconfig tree, but test edits of those and a restart (why > doesn't sending it a SIGHUP work?, it dies instead) doesn't change the > display at all. > > The chipset is nforce2, w-83627hf. When libsensors is used the scaling/offset stuff is taken from the /etc/sensors.conf file and you should find and edit the w83627hf section in that file. But with libsensors4 I think the config file becomes /etc/sensors3.conf. The version numbers are confusing and I don't if your libsensors.so.3.1.4 means you have libsensors3 or libsensor4. Anyway for your 5 volt supply edit the w83627hf compute line for "in3" in /etc/sensors.conf or /etc/sensors3.conf ... or maybe both! Yeah, gkrellm doesn't do anything with SIGHUP, something to look at. Bill ______________________________________________ Gkrellm mailing list [email protected] Read archives-join-leave-set RSS feed: http://archive.lists.netservicesgroup.com