Re: gkrellm: Floating point exception during startup

Bill Wilson schrieb:
> On Sun, 22 Feb 2009 11:04:33 +0100
> "Malte J. Wetz" <[email protected]> wrote:
> 
>> I was using gkrellm on my new netbook (Lenovo Ideapad S10) for a few
>> days without problems but lately, it refuses to start and instead
>> displays a xmessage:
>>
>> 	gkrellm floating point exception: (initializing)
>>
 >
> It would help if you can get a stack trace from a gkrellm compiled with debugging
> symbols. 

Thanks for your answer. I downloaded gkrellm-2.3.2 and built it from 
source according to your description.

Here's the log from my gdb session:


<---------------- snip ----------------->
(gdb) run
Starting program: /home/mjw/downloads/gkrellm-2.3.2/src/gkrellm
[Thread debugging using libthread_db enabled]
[New Thread 0xb754b700 (LWP 10348)]

Program received signal SIGFPE, Arithmetic exception.
[Switching to Thread 0xb754b700 (LWP 10348)]
0x080c1ee1 in __udivdi3 ()
Current language:  auto; currently asm
(gdb) bt full
#0  0x080c1ee1 in __udivdi3 ()
No locals.
#1  0x080ba62b in gkrellm_sys_battery_read_data () at sysdeps/linux.c:1876
         list = (GList *) 0x8222900
#2  0x08063c7d in gkrellm_init_battery_monitor () at battery.c:1295
No locals.
#3  0x0805e07d in main (argc=Cannot access memory at address 0x0
) at main.c:1961
         i = <value optimized out>
         s = (gchar *) 0xb78a8979 "\201{\003"
(gdb) quit
<---------------- snap ----------------->

Hope it helps.

Greetings,
   Malte

______________________________________________
Gkrellm mailing list
[email protected]
Read archives-join-leave-set RSS feed:
http://archive.lists.netservicesgroup.com
This service is provided by The Network Services Group:
http://www.netservicesgroup.com