instant monitor

i found a way to do it but it is a kludge. will search thru the gkrellm code to see if 
there are timing specs on getting data. i assume it uses the /sys entries to read the 
temps.. what i am doing temporarily is this :

watch -n 0.1 cat /sys/devices/platform/coretemp.0/temp1_input

if i were to do it within gkrellm, i would probably up the time between samples to 0.5 
seconds. it appears that between .1 and .5 i am not missing anything.

anyone know if the sampling rate for coretemp sensors is in a header file or within a code 
loop itself? (yeah i know im lazy :) )

i see an option in gkrellm config for temp graphs but i have yet to be able to see where 
they are graphed.

-- 

Rio


______________________________________________
Gkrellm mailing list
[email protected]
Read archives-join-leave-set RSS feed:
http://archive.lists.netservicesgroup.com
This service is provided by The Network Services Group:
http://www.netservicesgroup.com