Re: Echo tests on ekiga
Damien Sandras <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gnomemeeting |
|---|---|
| Message-ID | <[email protected]> |
Le lundi 23 février 2015 à 14:35 +0000, ael a écrit : > I am trying to understand properly how to navigate firewalls using > ekiga. I have read the wiki and even contributed to it in the past. > > Just now I using wireshark to compare a failed echo test (ekiga.net's own > on 500) and the ideal sip successful echo test when sent via ekiga net. > > ekiga is set to use udp_port_range (on this machine) of 5081:5089 and > the firewall forwards those ports & 5080 to this machine. The sip > listen_port is 5080. ATM I am testing audio only, so although > tcp_port_range is set to 30000:30010, the firewall is *not* forwarding > those ports. > > I attach the two simple (wide) text flow recordings from wireshark > of the successful and failed calls. Wireshark does not decode the > udp audio packets in the successful call, so that is not shown. > > In the failed call to [email protected], the first INVITE goes out, > and ekiga.net replies with the 407 Authentication request. > ekiga responds with the ACK and the modified INVITE, but ekiga.net > never responds (or is blocked by the firewall) thereafter. > > Is this enough for an expert to explain what is happening? > > I can of course post a -d4 log etc. if more information is needed, but I > wanted to keep this initial post simple and short. > > Thanks in advance for any enlightenment. My suspicion would be that too many audio codecs are enabled and you reach the MTU once the authentication information has been added : the packet never reaches ekiga.net. Can you try removing some codecs ? -- Damien SANDRAS Ekiga Project http://www.ekiga.org _______________________________________________ ekiga-list mailing list [email protected] https://mail.gnome.org/mailman/listinfo/ekiga-list