Re: [GNC-dev] Co-Owner
Ralf Zerres <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gnucash.devel |
|---|---|
| Message-ID | <[email protected]> |
Am Freitag, dem 10.06.2022 um 10:41 -0700 schrieb John Ralls: > > I did a test-build of your wip-coowner branch and had no trouble with > unittest-support.scm, so perhaps you have a build environment > problem. Digging in a bit deeper, i did found some typo. I had faulty references to *customer* where it should be *coowner*. The missing terms functions was added, sources changed and commited to the branch. I did push all changes and some new updates to the branch. Since it is WIP i used --force-with-lease. Just because i don't expect code changes from third party yet (I know about the trouble, if I would do this in published trees :( ). > If you're trying to develop on Win32, I suggest that you use WSL. > Developing directly in the MSYS2 environment is an exercise in > frustration. > Thank's again. Appreciate taken the time. But no, i'm primary developing on linux. And the toolchain seems to work quite well (using Arch Linux). > I didn't get a clean build, though: Linking libgncengine.so failed > because > > Undefined symbols for architecture x86_64: > "_gncCoOwnerGetTerms", referenced from: > _gncCoOwnerRegister.params in gncCoOwner.c.o > ld: symbol(s) not found for architecture x86_64 > > Examining the source shows there's no definition for > gncCoOwnerGetTerms. > With all that changes, the branch now compiles without any glitches. This status has me first of all already quite satisfactory! > Regards, > John Ralls > regards Ralf _______________________________________________ gnucash-devel mailing list [email protected] https://lists.gnucash.org/mailman/listinfo/gnucash-devel