Almost successful Gnumeric Windows build...

Technically, I have now successfully built Gnumeric to run in Windows 10 
using MSYS2.  Gnumeric launches and appears to match the version I run 
on Linux.

A few bugs left before I declare real success

1. Something in the configure or install is wrong, and Gnumeric can't 
get to the plugins.  A typical error in the msys console after launching 
gnumeric from that command line reads as follows (depending on the 
content of the sample spreadsheet I have opened).  It would appear 
something's wonky with the PATH gnumeric has been told to use, still 
trying to figure out where this bad PATH originates.  NOTE: I can go 
through the Gnumeric dialog to select plugin directories, but the error 
persists.

Failed to load rounddown
   E Unable to open module file 
"C:\msys64a\mingw64\lib\gnumeric\1.12.47\plugins\fn-math\plugin".
      E '/mingw64/lib/gnumeric/1.12.47/plugins/fn-math\': The specified 
module could not be found.
Failed to load trunc
   E Unable to open module file 
"C:\msys64a\mingw64\lib\gnumeric\1.12.47\plugins\fn-stat\plugin".
      E '/mingw64/lib/gnumeric/1.12.47/plugins/fn-stat\': The specified 
module could not be found.

2. Gnumeric is trying to access Windows registry entries that don't 
exist.  I suspect this one's completely on me --> I need to find a tool 
that helps automate the creation of an MSI file, I think...  Once this 
is fixed --> based on some of the names of those missing keys, I'm 
holding out hope that the very dated Windows build Gnumeric I'm 
currently using regularly will finally be replaced with this new version 
that will remember my macro settings when I close a file and then reopen 
it later (like the default window size...).  Hopefully this doesn't 
involve purchasing a Microsoft Development Suite....

Any hints or thought starters on the above are welcome!


_______________________________________________
gnumeric-list mailing list
[email protected]
https://mail.gnome.org/mailman/listinfo/gnumeric-list