Re: Newbie questions

David A. Desrosiers wrote:
> On Wed, 2007-08-22 at 23:25 -0400, Pete Holsberg wrote:
>   
>> Installed jpilot and it run but doesn't make the connection via 
>> /dev/pilot. ThePDA times out. 
>>     
>
> What do your udev rules look like? Which physical device does your Palm
> present itself as? (0 or 1?) 
>
> There's a detailed README I wrote on getting this to work properly: 
>
> http://www.pilot-link.org/README.usb
>
> And if you want to try using libusb (faster sync, no kernel module): 
>
> http://www.pilot-link.org/README.libusb
>
> Good luck!

I don't get a 1:1 correspondence to what you wrote, impressive as it is.

In kern.log, I see (when I connect the TREO tot the cable):

Aug 23 17:45:26 linux kernel: [117652.389706] usb 2-1: new full speed 
USB device using uhci_hcd and address 57
Aug 23 17:45:26 linux kernel: [117652.563492] usb 2-1: configuration #1 
chosen from 1 choice
Aug 23 17:45:26 linux kernel: [117652.568350] visor 2-1:1.0: Handspring 
Visor / Palm OS converter detected
Aug 23 17:45:26 linux kernel: [117652.568697] usb 2-1: Handspring Visor 
/ Palm OS converter now attached to ttyUSB0
Aug 23 17:45:26 linux kernel: [117652.568814] usb 2-1: Handspring Visor 
/ Palm OS converter now attached to ttyUSB1


When I hit the Hot Sync button, I get

Aug 23 17:46:15 linux kernel: [117701.459636] usb 2-1: USB disconnect, 
address 57
Aug 23 17:46:15 linux kernel: [117701.459940] visor ttyUSB0: Handspring 
Visor / Palm OS converter now disconnected from ttyUSB0
Aug 23 17:46:15 linux kernel: [117701.460038] visor ttyUSB1: Handspring 
Visor / Palm OS converter now disconnected from ttyUSB1
Aug 23 17:46:15 linux kernel: [117701.460058] visor 2-1:1.0: device 
disconnected
Aug 23 17:46:16 linux kernel: [117702.218275] usb 2-1: new full speed 
USB device using uhci_hcd and address 58
Aug 23 17:46:16 linux kernel: [117702.391552] usb 2-1: configuration #1 
chosen from 1 choice
Aug 23 17:46:16 linux kernel: [117702.396452] visor 2-1:1.0: Handspring 
Visor / Palm OS converter detected
Aug 23 17:46:16 linux kernel: [117702.396839] usb 2-1: Handspring Visor 
/ Palm OS converter now attached to ttyUSB0
Aug 23 17:46:16 linux kernel: [117702.396954] usb 2-1: Handspring Visor 
/ Palm OS converter now attached to ttyUSB1

When I then try

pilot-dlpsh -p /dev/ttyUSB1

I get

   ERROR: Specify exactly one of -c or -i

I'm using Xubuntu 7.04

Thanks.

_______________________________________________
gnome-pilot-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/gnome-pilot-list