Re: Newbie questions
Pete Holsberg <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.pilot |
|---|---|
| Message-ID | <[email protected]> |
David A. Desrosiers wrote: > On Thu, 2007-08-23 at 17:49 -0400, Pete Holsberg wrote: > >> Aug 23 17:46:15 linux kernel: [117701.459636] usb 2-1: USB >> disconnect, >> address 57 >> Aug 23 17:46:15 linux kernel: [117701.459940] visor ttyUSB0: >> Handspring >> Visor / Palm OS converter now disconnected from ttyUSB0 >> Aug 23 17:46:15 linux kernel: [117701.460038] visor ttyUSB1: >> Handspring >> Visor / Palm OS converter now disconnected from ttyUSB1 >> Aug 23 17:46:15 linux kernel: [117701.460058] visor 2-1:1.0: device >> disconnected >> Aug 23 17:46:16 linux kernel: [117702.218275] usb 2-1: new full speed >> USB device using uhci_hcd and address 58 >> Aug 23 17:46:16 linux kernel: [117702.391552] usb 2-1: configuration >> #1 >> chosen from 1 choice >> Aug 23 17:46:16 linux kernel: [117702.396452] visor 2-1:1.0: >> Handspring >> Visor / Palm OS converter detected >> Aug 23 17:46:16 linux kernel: [117702.396839] usb 2-1: Handspring >> Visor >> / Palm OS converter now attached to ttyUSB0 >> Aug 23 17:46:16 linux kernel: [117702.396954] usb 2-1: Handspring >> Visor >> / Palm OS converter now attached to ttyUSB1 >> > > The above snippet looks suspisciously like it connects, disconnects, > then reconnects again... I wonder if this is Yet Aother Palm where they > try to be sneaky with that "Drive Mode" garbage. > > Try this... disconnect your Palm, hit HotSync, count to 4, then connect > the cable, and *THEN* launch your pilot-xfer or pilot-dlpsh command > against either /dev/ttyUSB0 or /dev/ttyUSB1. You'll have to play around > with both of them to figure out which one is the right port for your > specific device and usb configuration. > > Also, make sure you're *NOT* using ehci_hcd for this; you have to use > uhci_hcd or ohci_hcd, depending on your specific motherboard chipset. > > If this doesn't work, we'll probably have to play with your specific > udev configuration. > > >> When I then try >> >> pilot-dlpsh -p /dev/ttyUSB1 >> >> I get >> >> ERROR: Specify exactly one of -c or -i >> > > And what happens when you do as requested? "pilot-dlpsh --help" will > provide you with explanations of both parameters. > I appreciate your help but as I did not have this problem with V6.10, I think I will reinstall it. _______________________________________________ gnome-pilot-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/gnome-pilot-list