Re: Problems with file conduit and Treo 680

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I made sure gpilotd had been killed before I ran pilot-xfer.  And I do
hear the sound (with gpilot-applet).  And I know the connection works,
because if I kill the gpilot-applet (and the file transfer), normal
syncs work.  So that means the modules usbserial and visor are loaded.
lsmod proves it:

> lsmod | grep visor
> visor                  23564  1 
> usbserial              37488  3 visor
> usbcore               154416  11 visor,usbserial,lmpcm_usb,xpad,usblp,usbhid,ehci_hcd,uhci_hcd

But as a final test, I tried it again... and pilot-xfer worked!  I did
have to hit the HotSync button just before I ran pilot-xfer.  I guess my
timing had been off before.  So I know it's transferring files.  Maybe
my timing was wrong with gpilot-install-file, as well?

Thanks!

David A. Desrosiers wrote:
> On Sat, 2007-09-22 at 03:17 -0500, Trey Blancher wrote:
>> And pilot-xfer -i hangs just the same.
> 
> And you tried pilot-xfer AFTER killing the gpilotd process from
> listening for connections on that port, right? 
> 
> Did you even hear the initial connect sound (the "tweedle-dee" sound)?
> If you didn't, then something other than gnome-pilot or pilot-link is at
> issue. Are you sure your visor module is loaded and functioning? Cable
> securely plugged in? USB interfaces loaded and ready? 
> 
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iQEVAwUBRvVhFJ76rTZSI4F7AQKDnwf/bwOQsuuCtR9+b5SXJjK/DuL+KioJoZ++
La7HXFKD6V4b05VDzs5Y4jUIgeY37pENB8NMdUV4y2gc63SJYdGh3m3wG5jVLmKZ
TXvgkZeb6mAaDj5AbknU9HCeA5JzNDkpW7V63OQIisFFkZTjQiiWyYjAvlVz/Zfi
o6nFzCy2Uhcic6XYs0B6X5gcHpNhx+7sn1DY7861I8+ZkO9nxuD0WGRyfow8Eu/9
oxmNjBxJ5HpQCYmq2X+r8jZH2Nglqz+Wwd5HSGtzE62KdjWhdR6gcEYG/p8/hNYd
BGvtqttNXhBNkLDsVyVRz9usdsfRFFRLPNQsZHA24pdC5SblMHtjrQ==
=tM43
-----END PGP SIGNATURE-----