Re: help with Palm Tungsten e2 in Debian 5.0

2010/1/14 L <[email protected]>:
> On Fri, Jan 15, 2010 at 12:12 PM, Fernando A. Rodriguez
> <[email protected]> wrote:
>> 2010/1/14 L <[email protected]>:
>>> On Fri, Jan 15, 2010 at 12:11 AM, Fernando A. Rodriguez
>>> <[email protected]> wrote:
>>>> Hi there, I was looking for some help in google and I didn't find how
>>>> to get success
>>>>
>>>> I would like configure my palm Tungsten E2 in my Debian. How could I s=
tart ?
>>>
>>> what do you mean "configure"?
>>> if you want sync, jpilot is a good choice under linux system
>>> http://www.jpilot.org/
>> --
>>
>> I mean that I have Jpilot installed
>> I have pilot-xfer pilot-link installed.
>>
>> I'd read in another forums that you have to bind /dev/ttyUSB0 to
>> /dev/pilot but "/dev/ttyUSB0" doesn't exist
>>
>> if I do
>> ln -s /dev/ttyS0 /dev/pilot or ttyS1
>> chmod 666 /dev/ttyS0
>>
>> jpilot return
>
> after you plug E2 and turn on, you can check what device was registered by
>
> at a terminal,
>
> dmesg
>
> this will show you what is your E2 device
>
>
>
>>
>> #pi_bind error: /dev/pilot Argumento inv=E1lido
>> #Revise su puerto serial y sus opciones
>> #Saliendo con estado SYNC_ERROR_BIND
>> #Finished.
>>
>> there's no much about how to sync Tungsten E2 :s
>> _______________________________________________
>> gnome-pilot-list mailing list
>> [email protected]
>> http://mail.gnome.org/mailman/listinfo/gnome-pilot-list
>>
>
>
>
> --
> http://etvillage.blogspot.com/
> _______________________________________________
> gnome-pilot-list mailing list
> [email protected]
> http://mail.gnome.org/mailman/listinfo/gnome-pilot-list
>

Thanks I get Success!!!!
I did this steps
1) plug the palm and press the hotsync button
2)while the palm is trying to sync, you can see that /dev/ttyUSB0 appears
3)ln -s /dev/ttyUSB0 /dev/pilot
4)press again the button sync and then sync your jpilot.