Re: [gnome-db] How to build libgda and use it with Vala

Hello,

I just found the bug I reported (it has the solution I was talking about):

https://bugzilla.gnome.org/show_bug.cgi?id=750462

Best,
Gergely
On 4 Sep 2015 20:21, "Gergely Polonkai" <[email protected]> wrote:

> Hello,
>
> There was a recent fix for that (I guess on master); I hope Vivien Malerba
> will join this thread on how to use it. Meanwhile, if you cannot go with a
> system-wide installation (assuming you are on a Linux box), you may want to
> modify the configure.ac file and change all occurence of 0.26 to 0.30.
>
> Best,
> Gergely
>
> Thanks Gergely and Daniel,
>
> I have Vala-0.29.2 on Linux Mint Mate which I have installed from source
> using the standard
>
> *./configure*
>
> *make*
>
> *sudo make install*
>
> vala, valac, vapicheck and vapigen are all in /usr/local/bin and
> libvala-0.30.so.0.0.0 is in /usr/local/lib
>
> When I run the command you have suggested
>
> ./autogen.sh --enable-vala --enable-vala-extensions
>
> The script halts with the following error:
>
> *checking for vapigen vapigen-0.26... no*
> *configure: Searching for vapigen-0.26 program...*
> *checking for vapigen-0.26... no*
> *configure: error: Can't locate vapigen-0.26 >= 0.26.0 program*
>
> It does not seem to accept vapigen-0.30 as > vapigen-0.26.0
>
> I created a symlink as vapigen-0.26.0 and that got me past this error but
> then I got a similar error message for libvala and the symlink trick
> wouldn't work for that. Is it a bug or did I do something wrong?
>
> Regards
>
> Steve
>

_______________________________________________
gnome-db-list mailing list
[email protected]
https://mail.gnome.org/mailman/listinfo/gnome-db-list