Re: Any gob2 autoconf/automake macros?

Hi Behdad,

Of course, but that still doesn't answer the question of how I can
trigger make to automatically  generate the .[ch] files files from the
gob files if they change. I.e. on one hand I want to have make do the
correct building (through autoconf/automake) and on the other hand I
don't want to make "configure; make install" dependent on gob2.

Dov

On 1/28/07, Behdad Esfahbod <[email protected]> wrote:
> On Sun, 2007-01-28 at 03:45 -0500, Dov Grobgeld wrote:
> > Hello,
> >
> > I was wondering if anyone has written any autoconf/automake macros
> > that allow running gob2 during autoconf/automake , and thus does not
> > require the installation of gob2 for the end user who is doing
> > ./configure ; make install ? I have successfully used that technique
> > for running doxygen, and it then occured to me that it would make
> > sense doing the same for gob2.
>
> Hi Dov,
>
> I think all you need to do is to add the generated files to EXTRA_DIST.
>
> Regards,
> behdad
>
> > Regards,
> > Dov
>
> --
> behdad
> http://behdad.org/
>
> "Those who would give up Essential Liberty to purchase a little
>  Temporary Safety, deserve neither Liberty nor Safety."
>         -- Benjamin Franklin, 1759
>
>
>
>



--
to unsubscribe:
send mail to [email protected] with "unsubscribe gob-list" in the subject