Re: UI freeze exceptions request for control-center/printers

Thank you all!

On 25 Feb 2017 6:59 pm, "Matthias Clasen" <[email protected]> wrote:

Yeah, looks ok to me too. Even though ellipsizing is always a bit of an
admission of failure.


As in design flaw?


+1 from me.

On Fri, Feb 24, 2017 at 4:55 PM, Michael Catanzaro <[email protected]>
wrote:

> Hi,
>
> On Fri, 2017-02-24 at 22:36 +0100, Felipe Borges wrote:
> > 1. ellipsizing of strings (two strings were causing the windows to
> > expand horizontally, which is undesirable).
> > https://bugzilla.gnome.org/show_bug.cgi?id=779071
>
> I don't think you even need to request permission for this one. Freeze
> is intended to discourage you from making big changes at this point in
> the cycle, not to discourage you from making small changes that fix
> obvious bugs. Go ahead.
>
> > 2. the new printers panel comes with a graphic supply level bar which
> > used to contain primary colors, but the designers and their mockups
> > would rather have these colors a bit de-saturized for "eye-candy"
> > purposes.
> > https://bugzilla.gnome.org/show_bug.cgi?id=779075
>
> Since this is a fairly small change, approval 1 (of 2) from me.
>
> Michael
> _______________________________________________
> [email protected]
> https://mail.gnome.org/mailman/listinfo/release-team
> Release-team
> <https://mail.gnome.org/mailman/listinfo/release-teamRelease-team>
> lurker? Do NOT participate in discussions.
>


_______________________________________________
gnome-doc-list mailing list
[email protected]
https://mail.gnome.org/mailman/listinfo/gnome-doc-list