Re: Running GLADE in-place
Tristan Van Berkom <[email protected]>
| Newsgroups | gmane.comp.gnome.glade.devel |
|---|---|
| Message-ID | <[email protected]> |
On Fri, Jun 19, 2009 at 7:46 AM, Sam Thursfield<[email protected]> wrote: > Hey guys > I've searched the archives and various places and not found any advice on this. > > Is there an easy way to run GLADE out of its source tree, to save > doing a full 'make install' every time I change catalog/plugin code? > GLADE_MODULE_PATH seems the obvious way, but doesn't work because at > this point the plugins are libtool wrappers. > > It would be worth putting something in the HACKING file about this, I > wasted half a day wondering why I was getting weird struct mismatch > issues before I realised the obvious: it was using installed plugins > still .. :) I would just say no. No there has never to my knowlage ever been a way to run Glade from the tree without installing it. Just install it, if you dont have system permissions then just configure/install somewhere in your home dir. Cheers, -Tristan _______________________________________________ Glade-devel maillist - [email protected] http://lists.ximian.com/mailman/listinfo/glade-devel