Re: [Glade-users] Program debugging in GPS 2013

On Wed, 2014-04-30 at 09:17 +0200, Bertus Dries wrote:
> I have some troubles in debugging a program in which I do use a glade file 
> for creating the GUI. The problem is the fact that I cannot find the reason 
> why the Do_Connect function fails. The normal reason I found was that the 
> names of the handlers in the glade file and in the program file are not 
> completely the same. I now have the problem that I introduced a new dialog 
> within an existing glade file with two buttons that have a "clicked" 
> activation. Afterwards I did not pass the Do_Connect routine but when I made 
> sure the handler names were the same by a copy/paste operation it still did 
> not work. My problem is that I cannot find a way to get the the program  to 
> tell me what creates the trouble. At this moment I have stripped all events 
> from the glade file and commented all register handlers out but the programs 
> still stops at the do_connect routine. Icannot enter the routine with the 
> GPS debugger, so what is the best way to handle the problem. Starting all 
> over again in a program of several thousands of program lines is certainly 
> not the best way.

Hi you need to be a little more specific about your environment,
which language are you using?
Its better to refer to the language binding documentation to know
exactly how your functions/method map in builder handler names

BTW, is there any output in the console when you run your program?

cheers

JP

_______________________________________________
Glade-devel maillist  -  [email protected]
http://lists.ximian.com/mailman/listinfo/glade-devel