Re: [glade--] Learning to use glademm-generated code

J. Baltasar García Perez-Schofield schrieb:
> 	I have installed automake1.9. Hope this will make the work.

I added the tests for 1.9 to glade-- (CVS)

>>>./autogen.sh: line 49: gettextize: command not found
>>
>>Ah, here's the problem. Either turn off gettext support in glade-2's C
>>options or install gettextize (which populates the po and intl dirs).
> 
> 
> 	All right  ... actually, gettext was installed ... it was the package 
> gettext-devel the one which was missing ...

(quoted for the archives)

> 	Oh, well, I should say that configure.sh ends with an error, but the 
> application compiles and runs:
> 
> Making all in po
> gmake[2]: Entering directory `/home/baltasarq/prys/glade-sumador2/po'
> gmake[2]: *** No hay ninguna regla para construir el objetivo 
> `/config.status', necesario para `Makefile'.  Alto.
> gmake[2]: Leaving directory `/home/baltasarq/prys/glade-sumador2/po'

Oh dear. It looks like I have not mastered the gettext/automake/autoconf 
combination, yet.

    Christof

_______________________________________________
glademm-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/glademm-list

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Debian - http://enigmail.mozdev.org

iD8DBQFBvwf5ng+R+0ucfO0RAvUeAJsFFDmTTBFemc65tlkW8XlSTHu/wgCgtMDb
YUKqs4QS8+ArHFbf7mxeHzM=
=9Odw
-----END PGP SIGNATURE-----