Re: Why does glib-networking hardcode automake 1.10 - 1.11?

I'm working from the tip of git://git.gnome.org/glib-networking(commit
f8d0a44). I've already opened a bug report and submitted a patch
here:

https://bugzilla.gnome.org/show_bug.cgi?id=675261

If you check the diff, the old version hard coded to use only 1.10 and 1.11.

- William

On Mon, Apr 30, 2012 at 11:41 PM, Aljosha Papsch
<[email protected]>wrote:

> Am Montag, 30. April 2012, 22:34:05 schrieb William Ting:
> > Hi,
> >
> > I regularly build Epiphany for development. Last night after I updated my
> > system, it bumped automake to 1.12.1. However this breaks glib-networking
> > build because it's hardcoded to only support 1.10.x and 1.11.x.
> >
> > Obviously I can rollback my system's automake to an older version, but is
> > there a reason glib-networking is hardcoded to use specific versions
> rather
> > than 1.10+?
> >
> > - William
>
> Which version of glib-networking are you using? Version 2.32.1 here
> requires
> Automake 1.11  or later. You could try and remove the version from
> AM_INIT_AUTOMAKE options (in glib-networking in configure.ac on line 10),
> instead of rollback.
>
> Aljosha
> _______________________________________________
> gnome-love mailing list
> [email protected]
> http://mail.gnome.org/mailman/listinfo/gnome-love
>

_______________________________________________
gnome-love mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/gnome-love