Re: glib-2.0.1 installation problems..

Hi Erik,

glib-2.0 is _not_ downward compatible with glib-1.2.  But they are 
parallel installable. If you have a program which needs glib 1.2.x it 
just won't work with glib-2.0. Install both libraries (with the same 
prefix) on your computer.

   Jens

BTW: A better place to discuss this seems to be [email protected] I 
think.

Erik Ljungström wrote:
> I d/l a program that required glib > 2.0.0 
> Therefore I first removed my current glib (1.2.10) and downloaded 
> glib-2.0.1. I followed the installation instructions very thorowly.
> Then I tried to configure a program that required the glib.
> I got the following output;
> 
> checking for GLIB - version >= 1.2.6...
> *** 'glib-config --version' returned 2.0.1, but GLIB (1.2.10)
> *** was found! If glib-config was correct, then it is best
> *** to remove the old version of GLIB. You may also be able to fix the error
> *** by modifying your LD_LIBRARY_PATH enviroment variable, or by editing
> *** /etc/ld.so.conf. Make sure you have run ldconfig if that is
> *** required on your system.
> *** If glib-config was wrong, set the environment variable GLIB_CONFIG
> *** to point to the correct copy of glib-config, and remove the file config.cache
> *** before re-running configure
> 
> I assume that the removepkg of glib removed all the rests of 1.2.10. But apparently, no. I have looked through every header file in the include/glib-2.0 
> dir, without success. I also looked through the pkgtool/ dir, and all the .pc
> files were correct. What is this all about? What can be left from 1.2.10? 
> 
> And Q #2; Why does glib require pkgtool, which sets glib-1.2.8 as default? I 
> changed this script by hand to get it working.