Re: ximian-connector with Exchange 2003

On Tue, 2004-10-19 at 14:39 -0400, James Rinehart wrote:
> Ok... maybe this has been covered previously... but i had
> ximian-connector with Evolution 1.4 working fine in our M$Exchange
> legacy environment.  We just moved our mail over to Exchange 2003... I
> am consistantly having the same issue.  I get the issue even after i
> removed ximian-connector and Evo 1.4... I run Suse 9.1, so i installed
> the dev train of Evolution 1.5 and ximian-connector.  I also used
> ximian-connector-setup-2.0 to set up the connection to the exchange
> server... I can make make everything work except for the
> authentication... to which I get the following error:
> 
> [Could not authenticate to server.  (Password incorrect?)
> Enter password for #########@#########.com]
> 
> I have a buddy here that is running Gnome and FreeBSD who was also
> working fine with the exchange connector until the switch to Exchange
> 2003.
> 
> I know that someone must have an answer for this.  Is it possible that
> the turds at the NT group have a "screw the Unices" switch turned on??
>  Any help would be appriciated.

It's possible.  Exchange 2003 is supported, but that doesn't mean the
servers are necessarily configured to allow it.  I'm not sure what needs
to be done (other than OWA being enabled), but there's a
[email protected] mailing list...

-Mark Gordon

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQBBdWpXHt3jrv3+a8IRAnCRAJ9v4AWCAs3GfsOx8Nd3EXmJkAPXdwCgtCV/
y70jZESOMYeN91uICF1jSRY=
=98NJ
-----END PGP SIGNATURE-----