Re: How do I switch the mouse buttons in flyspell mode in emacs?

 I am back to square one, because this remapping [down-mouse-3] has a side effect: normally down-mouse-3 is used for (mouse-save-then-kill CLICK) - and I will lose that functionality (left click, then right click at a different location to highlight the entire region) if I remapping it to 'flyspell-correct-word. Unless this is a bug... 

Anybody?

-----Original Message-----
From: Tony An 
Sent: Thursday, April 14, 2011 8:53 PM
To: [email protected]
Subject: RE: How do I switch the mouse buttons in flyspell mode in emacs?

Found a solution:

(eval-after-load "flyspell"
'(define-key flyspell-mode-map [down-mouse-3] 'flyspell-correct-word))

________________________________________
From: Tony An
Sent: Wednesday, April 13, 2011 7:46 PM
To: [email protected]
Subject: How do I switch the mouse buttons in flyspell mode in emacs?

I found it's rather odd that in flyspell mode in emacs, if a word is marked mis-spelled, I should press the middle mouse button to get the list suggested words, not the right mouse button, which does nothing.

Since I am using a wheel mouse, my middle button is the wheel - not only it's hard to click on, it also sometimes mistaken as "paste" if I do click on it outside the popup suggestion menu.

Is there a way I can weak the buttons so that I can use the right mouse button to bring up the menu of suggested words in flyspell mode? I think that should be default behavior as most "menu" type of lists are brought by right mouse button instead of the middle button.

Thanks for any tip about this.

Tony