RE: Intel Dialogic System Release 6.1 and Bayonne

Tony,

I have never used gc_basic_call_model with analog hardware. The basic idea
is that you uncomment one of the lines that corrospond to the hardware.
Currently I am out of station. When I get back, I would check out
gc_basic_call_model with this card and let you know if there are any special
settings..

Regards,

Ambar Roy

One97 Communications Pvt. Ltd.
701 Arunachal Building,
19 Barakhamba Road,
New Delhi - 110001

+91-9810094479
[email protected] 

> -----Original Message-----
> From: Tony Stocker [mailto:[email protected]] 
> Sent: Wednesday, August 03, 2005 11:18 PM
> To: mailing_list_bayonne-devel
> Subject: Re: [Bayonne-devel] Intel Dialogic System Release 
> 6.1 and Bayonne
> 
> Ambar,
> 
> Okay I've gotten to the point where I want to try running the
> gc_basic_call_model.  I'm looking at the config file for it and I
> don't know what options to use for my hardware.  Do you know where I
> can find this type of information?
> 
> I'm using a D/41JCT-LS board if that helps.
> 
> Thanks!
> 
> Tony
> 
> On 7/26/05, mailing_list_bayonne-devel <[email protected]> wrote:
> >  Hi Tony,
> > 
> > You can always download and run SR 5.1 and install the SP1. 
> Although 6.1
> > should be fully backward compatible with 5.1.
> > 
> > First set up 6.1 and run some sample programs. 
> Gc_basic_call_model is a good
> > one to try. And then try running bayonne.
> > 
> > Regards,
> > 
> > Ambar Roy
> > 
> > > -----Original Message-----
> > > From: Tony Stocker [mailto:[email protected]]
> > > Sent: Tuesday, July 26, 2005 2:21 AM
> > > To: [email protected]
> > > Subject: [Bayonne-devel] Intel Dialogic System Release 
> 6.1 and Bayonne
> > >
> > > Hello All,
> > >
> > > We recently purchased an Intel Dialogic D/41-JCT-LS board and the
> > > System Release 6.1 for Linux with the intention of 
> installing it for
> > > use with Bayonne.  However the documentation at
> > > http://www.gnu.org/software/bayonne/documentation.html 
> seems to refer
> > > only to version 5.1 and talks about needing three 
> different packages
> > > (Service Release, Service Pack, Feature Pack) and the CD that we
> > > received from Intel only seems to have one package on it.
> > >
> > > I'm curious to know if anyone has setup Bayonne with a 
> Dialogic board
> > > and the 6.1 system release.
> > >
> > > Thanks,
> > >
> > > Tony
> > >
> > >
> > > _______________________________________________
> > > Bayonne-devel mailing list
> > > [email protected]
> > > http://lists.gnu.org/mailman/listinfo/bayonne-devel
> > >
> > >
> > 
> >
> 
> 
> _______________________________________________
> Bayonne-devel mailing list
> [email protected]
> http://lists.gnu.org/mailman/listinfo/bayonne-devel
> 
>