Re: configure without srtp

David Sugar <[email protected]> Fri, 03 Nov 2006 05:35:27 -0500
Newsgroups gmane.comp.gnu.ccrtp.devel
Message-ID <[email protected]>
I would be happy to distribute a new point release with that change when 
  it is ready.

Werner Dittmann wrote:
> Just looked at the code - IMHO its possible with a few changes inside
> the CryptoContext source. Just give me a day or two and I can check in
> the modifications.
> 
> Regards,
> Werner
> 
> 
> 
> 
> David Sugar wrote:
>> And I think this is a valid reason to investigate if we can get
>> --disable-srtp to build cleanly again.  If you would like to make a
>> patch that makes this possible, we could look at the possibility of
>> incorporating it for the next release.  I have built past versions for
>> embedded use also, using open embedded.
>>
>> Rini van Zetten wrote:
>>> Hi Werner,
>>>
>>> Thanks for your answer.
>>> We want to use the ccRTP on an embedded system so exclude dependencies on
>>> other libraries is preferred.
>>>
>>> Regards,
>>> Rini
>>>
>>>
>>>
>>> ----- Original Message ----- From: "Werner Dittmann"
>>> <[email protected]>
>>> To: "Rini van Zetten" <[email protected]>
>>> Cc: <[email protected]>
>>> Sent: Tuesday, October 31, 2006 8:40 PM
>>> Subject: Re: [Ccrtp-devel] configure without srtp
>>>
>>>
>>>> Rini,
>>>>
>>>> this disable option is a leftover from the development phase. SRTP
>>>> is now an integral part of ccRTP. To enable the use of SRTP you
>>>> have to setup a CryptoContext (there is an example in den demo
>>>> directory)
>>>> and register this with the RTP stack. If your program doesn't do this
>>>> then SRTP code is not executed.
>>>>
>>>> Is it necessary or you to have GNU ccRTP without SRTP?
>>>>
>>>> Regards,
>>>> Werner
>>>>
>>>> Rini van Zetten wrote:
>>>>> Hello  list,
>>>>>
>>>>> just downloaded ccrtp 1.5.0 and try to build it without srtp, so i
>>>>> configured with --disable-srtp
>>>>>
>>>>> configure succeeds but when i run make i get undifened errors to
>>>>> hmac_sha1 an the class AesSrtp
>>>>>
>>>>> Is it possible to build without srtp, and if, what did i wrong ?
>>>>>
>>>>> Regards,
>>>>>
>>>>> Rini
>>>>>
>>>>>
>>>>> ------------------------------------------------------------------------
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> Ccrtp-devel mailing list
>>>>> [email protected]
>>>>> http://lists.gnu.org/mailman/listinfo/ccrtp-devel
>>>
>>>
>>> _______________________________________________
>>> Ccrtp-devel mailing list
>>> [email protected]
>>> http://lists.gnu.org/mailman/listinfo/ccrtp-devel
>

_______________________________________________
Ccrtp-devel mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/ccrtp-devel
dsugar.vcf (text/x-vcard, 174 B)
begin:vcard
fn:David Sugar
n:Sugar;David
org:Tycho Softworks
email;internet:[email protected]
tel;work:+1 201 215 2609
url:http://www.tychosoft.com
version:2.1
end:vcard