Re: treecc compilation under Mingw...

Hi Aleksey, Klaus,

Thanks a lot for the suggestions. Based on the suggestions I was able to
compile the treecc directory. Following were the changes that I had to do:

1, reinstalled mingw and msys in different directories - to avoid clash in
make, etc functions.
2. removed cygwin from the path. i could not find it in the environment
variable, so i changed the cygwin install folder name.
3. unzipped msys - bison using Winrar. Winzip extracts have some new line,
etc, problems.

So the 'configure' and the 'make' steps have succeeded.

I am working on the 'make install' command  to work - it gives the 'install'
not found error. There is a 'install-sh' in the directory, i will check how
it needs to be run.

Thanks and Regards,
Bikram






On 6/10/06, Aleksey Demakov <[email protected]> wrote:
>
> Hi Bikram,
>
> > I believe I need to modify the following section in the 'configure'
> > generated makefile:
> > -------
> > # FIXME: We should only use cygpath when building on Windows,
> > # and only if it is available.
> > .c.obj:
> >  $(COMPILE) -c `cygpath -w $<`
> >
> > .s.o:
> >  $(COMPILE) -c $<
> >
> > .S.o:
> >  $(COMPILE) -c $<
> > -------
> >
> > But I could not figure out how to make it work, it would be great if I
> could
> > get some help in resolving this issue.
> >
>
> It looks like this code is generated automatically from automake built-in
> macros. Actually automake uses the CYGPATH_W  variable and configure
> substitutes it with "cygpath -w" if it finds it. So perhaps there is
> cygpath
> somewhere in your PATH.
>
> Ragards,
> Aleksey
>

_______________________________________________
Developers mailing list
[email protected]
http://dotgnu.org/mailman/listinfo/developers