Re: glp_intopt runs forever (related to Dusan Plavak's issue)

Dušan Plavák <[email protected]>
Newsgroups gmane.comp.gnu.glpk
Message-ID <CAPAgOKX6b9v9mdykBm0D+xe_GXC40H0EXLbLOKx4bbb8VYMw8Q@mail.gmail.com>
Hi Chris,

we found out that the looping forever on this example manifests on the
version 4.59 onward i.e. with 4.58 it still ran successfully.

We tested all the versions from 4.58 to 4.61 on the same environment.

Best regards

On Mon, Jun 12, 2017 at 11:09 AM, Chris Matrakidis <[email protected]>
wrote:

> Dear Rafael,
>
> > even after scaling your model the ratio between minimum and maximum
> > coefficient in the matrix is very big. See below.
>
> I agree that Heinrich's explanation is the most likely one. However I
> am curious why this change of behaviour happened with version 4.61.
> There are no changes in this version that should affect the simplex
> method execution. Did you change anything else in your environment
> (like C compiler or compilation flags)? Or are you comparing against
> an older version of GLPK (and if so which one)?
>
> Best Regards,
>
> Chris Matrakidis
>
> _______________________________________________
> Help-glpk mailing list
> [email protected]
> https://lists.gnu.org/mailman/listinfo/help-glpk
>



-- 
S pozdravom Dušan Plavák

_______________________________________________
Help-glpk mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/help-glpk
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.