Re: coupling again. was: Re: Qucs, Gnucap etc. Code

On 10/07/17 12:19, Felix Salfelder wrote:
> On Mon, Jul 10, 2017 at 11:07:40AM +0100, Richard Crozier wrote:
>> I decided to have another go at this. I probably shouldn't have but I just
>> pulled the autotools branch and built and installed using the autoools to
>> see if it worked. This went ok, when I try to run gnucap I get:
>>
>> [..]
>>
>> load gnucap-default-plugins.so
>>       ^ ? plugin not found in @pkglibdir@
> 
> Dear Richard.
> 
> sorry for not testing the autotools branch very well. i can fix this,
> probably later this week.
> 
> on the positive side: we have redesigned the module loader, it should
> now provide a much better experience. please give the "develop" (former
> "unstable") branch a try. just ./configure; make install should do it.
> 
> cheers
> felix
> 


Ah-ha, I was looking for 'unstable'. I have successfully built both 
gnucap and gnucap-coupling. Thanks for the help.

Richard

-- 
The University of Edinburgh is a charitable body, registered in
Scotland, with registration number SC005336.