Re: [Help-gnucap] print sub circuits voltage nodes

On Tue, Jun 26, 2012 at 11:57:16PM -0700, timothy3g wrote:
> how do you get the voltage nodes of sub circuits to print 
> and is there wiled card for nodes only and not devices or blocks
> sim runs but i cant get to see the internal nodes.

Hi Timothy

this is implemented in the gnucap-uf branch. see examples/Xprobes.gc
there.

unfortunately there is no Xprobes patch for upstream gnucap. the state
is approximately as follows.

- gnucap-uf is rather experimental (don't use if you don't have to)
- the node allocation scheme has been changed a bit, this might
  interfere with the probe lookup.
- changes are not fully upstream compatible, they break reverse-dot
  notation iirc.
- the (old) git history is a bit messy, changes might not be arranged in
  a useful way.
- i have forgotten some of the details

i can help writing an upstream patch. either from scratch or inspired
by gnucap-uf. i'm sorry i don't have time to propose a patch myself very
soon.

regards
felix

-- 
()  ascii ribbon campaign - against html e-mail
/\  www.asciiribbon.org   - against proprietary attachments