model for PIN diode in gnucap

vsrk sarma <[email protected]>
Newsgroups gmane.comp.gnu.gnucap.general
Message-ID <[email protected]> 
Hi,
I am just starting to use gnucap for circuit simulation.
Can diode model generated in gnucap  b e used for PIN diodes?
I need to find a equivalent an obsolete & unavailable silicon pin
diode used in protection/attenuation front end of amplifier.
Target diode manufacturer provides following spice model
parameters: Is, Rs, N, Cjo, Cp, M, EG, Vj, BV, IBV. (In gnucap
Cp, BV, IBV are not used). Are these sufficient to simulate
 protection/attenuation behavior with pulsed VHF input?
 Do the simulation take care of resistance & capacitance variation due to
 space charge accumulation in i layer?

-- 
vsrk sarma
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.