Re: Problems using measure command

On Wednesday 02 December 2009, Rubén Gómez Antolí wrote:
> I think that I miss something using measure command.
> I follow Gnucap's wiki manual:
> http://gnucap.org/dokuwiki/doku.php?id=gnucap:manual:commands:measure
> 
> I want to get the RMS value of a signal in a circuit, for it
>  I do:
> 
> gnucap> probe tran i(RMEASA)
> gnucap> tran 0 10ms 50us uic
> #Time       i(RMEASA)
>   0.         0.
>   50.u       0.0020859
>   100.u      0.0033786
>   150.u      0.0041567
>   200.u      0.0046241
>   250.u      0.0049039
>   300.u      0.0050698
>   350.u      0.0051667
> 
> (...)
> 
>   0.0099    -0.0053322
>   0.00995   -0.0053357
>   0.01      -0.0053384
> gnucap> measure eficaz = rms(probe="i(RMEASA)")
> no match: i(RMEASA)

Thanks for the comments .. the documentation needs improvement.

I have made some changes to the documentation to try to clarify this.
Look again.  Hopefully it is better now.

http://gnucap.org/dokuwiki/doku.php?id=gnucap:manual:commands:measure