Re: print command

Thanks, Orestes.

I discovered the vdb command and it solve a part of my trouble.

But...

I want to put, at same place, current and voltage graph. Current is much
smaller then voltage, then I want to multiply the value of current by 50,
because this way I can see both as well as. Is there a manner to do it
directly from gnucap command? Something like "print ac v(vl) 50*i(rl)"?

Regards!
Thiago


On Fri, Dec 11, 2009 at 12:43 PM, Orestes Mas <[email protected]> wrote:

> A Dijous, 10 de desembre de 2009 13:56:12, Thiago de Paiva va escriure:
> > Hello, folks!
> >
> >
> > I'm new on gnucap and its my first message in this list.
> >
> >
> > In help-gnucap archive I read instructions like
> >
> > print db(v(1))
>
> You must specify the analysis type (op, dc, tran, ac, fourier) after
> "print"
> keyword.
>
> Greetings,
>
> Orestes.
>
>
> _______________________________________________
> Help-gnucap mailing list
> [email protected]
> http://lists.gnu.org/mailman/listinfo/help-gnucap
>