Re: How to build libtool from git sources properly?
Bob Friesenhahn <[email protected]>
| Newsgroups | gmane.comp.gnu.libtool.general |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 18 May 2016, Igor Zhbanov wrote: >> >> run `./bootstrap` >> -mike > > It doesn't work on a PC without git or without network connection > because it needs to clone gnulib (although there is no gnulib folder > in libtool-2.4.6.tar.gz. But this is probably another story. This is very unfortunate. I am not sure if it would work if you cloned gnulib on another computer and copied the gnulib folder into place since it may still make subsequent git accesses. The bootstrap requirements make it difficult to support or test on targets which can not run git or don't have network access. Bob -- Bob Friesenhahn [email protected], http://www.simplesystems.org/users/bfriesen/ GraphicsMagick Maintainer, http://www.GraphicsMagick.org/ _______________________________________________ https://lists.gnu.org/mailman/listinfo/libtool