Re: Is it possible to break from a GMAKE foreach loop and then exit from make?
Pierre Rouleau <[email protected]>
| Newsgroups | gmane.comp.gnu.make.general |
|---|---|
| Message-ID | <CALTqLiYQjeYJ0M66rzY8iFQrxjaYwz22N72yCRzF8oEthTGepA@mail.gmail.com> |
On Mon, May 30, 2022 at 1:52 PM Paul Smith <[email protected]> wrote: > > It may not be worth worrying about until you actually start to run into > problems. Premature optimization is the cause of a lot off issues in > programming, and also build systems :). > That's for sure! -- /Pierre