Rép. : MCSim questions

Hi Rudy,

I cc this to the help mcsim list, as it is of general interest...

Yes, the easy way to do this is to us the SetPoint() simulations. You can =
actually take an MCMC output file straight as a SetPoint input parameters' =
file.
You can also create such a file yourself to have a grid sampling, or a =
specific need (like sensitivity analysis: you can use Simlab (from A. =
Saltelli) to generate
parameter vectors and then input them in MCSim to run your model, the =
output can them be further processed by Simlab).

Frederic


>>> "Gunawan, Rudy" 19/10/2010 19:35 >>>

...

I have a small question, may be trivial for you. I would like to know how =
I can run a MCSim simulation if one or more of the parameters has an array =
of values ? Preferably, if I can automate parameter assignment by reading =
the values from .txt file, for example. The idea is I would like to make a =
simulation out of the MCMC MCSim outputs. It's quite like Monte Carlo =
runs, but it is not. I hope it is not confusing. Thank you very much for =
all your help.


Regards,


Rudy

__________________________________________________
Rudy Gunawan, Ph. D
Post Doctoral Research Associate
Biological Monitoring/Modeling
Pacific Northwest National Laboratory