AW: Configure problems with octave4.2.1 on redhat7

Hello Markus 

You are right. Sorry I forgot the command. I recognized that the structure package is missing. That's why I tried to install it  from my net user directive

>> pkg install /net/hfbf34/Benutzer/wr0itvr/04_Software/GNU_OCTAVE/mypkg/struct-1.0.16.tar.gz

Best regards,
Ingo

Ingo Grunow
Berechnung&Simulation



Am Tafelacker 2
38104 Braunschweig

BIK:            611-197701
Handy:       0172-5464937

Mail: [email protected]


-----Ursprüngliche Nachricht-----
Von: Markus Mützel <[email protected]> 
Gesendet: Mittwoch, 25. November 2020 08:29
An: Grunow, Ingo (EXTERN: ARkentec) <[email protected]>
Cc: Help GNU Octave <[email protected]>
Betreff: Re: Configure problems with octave4.2.1 on redhat7

Am 25. November 2020 um 08:22 Uhr schrieb "Grunow, Ingo (EXTERN: ARkentec)":
> Hello Markus
> 
> Thanks for your reply. Please find the error output from the command window attached in the file OCTAVE_output.txt.  I listed the pkg pathes below.
> Packages are installed in the 'm'-directory (s. Lnx_sreen.png). When I do the pkg rebuild there is no message.  
> %=====================================================================
> =====================
> >> pkg rebuild
> >> pkg list
> no packages installed.
> >>
> %=====================================================================
> ===================== 
> %=====================================================================
> =====================
> >> pkg prefix
> Installation prefix:             /appl/opensoft/octave/4.2.1/redhatel7/octave/4.2.1/share/octave/4.2.1/m
> Architecture dependent prefix:   /appl/opensoft/octave/4.2.1/redhatel7/octave/4.2.1/share/octave/4.2.1/m
> >> pkg global_list
> /appl/opensoft/octave/4.2.1/redhatel7/octave/4.2.1/share/octave/4.2.1/
> m
> >> pkg local_list
> /net/home/wr0itvr/.octave_packages
> >> OCTAVE_HOME()
> ans = /appl/opensoft/octave/4.2.1/redhatel7/octave/4.2.1
> >>
> %=====================================================================
> =========================
> 
> Best regards,
> Ingo

Please, keep the mailing list in CC so that others can following and maybe chime in as well.

None of the commands you sent in this mail raised an error.

Please, show the commands *that triggered the error you initially reported* with their complete output.

Markus