Re: Current Transformer- Error measurement

Adjust the x and y axes scales properly. And the original picture might
have been produced in MATLAB, if you are worried about cross markings.

On Sun, Dec 13, 2020, 4:47 PM swagata Mukherjee <[email protected]>
wrote:

> Hi All,
> I am trying to implement a function for measurement of current transformer
> error as per paper titled "Determine Current Transformer Suitability Using
> ATP" by Ralph Folkers.
>
> The ratio measurement is ok - but not getting phase angle measurement as
> per the paper.
>
> Need some help in resolving this.
>
>  What I am getting is as follows:
> [image: image.png]
> What is expected is as follows:
> [image: image.png]
> Regards,
> Swagata
>
>